Author Topic: calibrate outer bounds after stick replacement?  (Read 536 times)

Offline Dockie

  • Guppy
  • *
  • Posts: 2
  • Post quality +0/-0
  • Acidmods User
calibrate outer bounds after stick replacement?
« on: August 01, 2021, 03:45:19 AM »
Sorry for the rubbish title, but i didn't know how to word this issue

essentially after a stick replacement, diagonal movement maps right up to 100/100 on the x/y axis' whereas an untouched stick will map a curve crossing over at roughly 70/70


Left stick replaced, Right stick original


The main problem I've found arises in fps games, the movement stick isn't much of an issue with this happening, but when looking around, the diagonals get exaggerated and become 'sticky' and less fluid. Is there any known way to correct this?
« Last Edit: August 01, 2021, 03:52:23 AM by Dockie »

Offline zis2104

  • Who Farted ???
  • *
  • Posts: 208
  • Post quality +0/-0
  • Acidmods User
Re: calibrate outer bounds after stick replacement?
« Reply #1 on: August 02, 2021, 03:23:57 PM »
Sorry for the rubbish title, but i didn't know how to word this issue

essentially after a stick replacement, diagonal movement maps right up to 100/100 on the x/y axis' whereas an untouched stick will map a curve crossing over at roughly 70/70


Left stick replaced, Right stick original


The main problem I've found arises in fps games, the movement stick isn't much of an issue with this happening, but when looking around, the diagonals get exaggerated and become 'sticky' and less fluid. Is there any known way to correct this?



you would have had to measure the old sensor and replace it with one that is closest to the value, and then eventually calibrate it

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal