Problem after replacing analog DS4 ( JDM-055)

[jvcj]

After replacing the analog, I encountered the problem that the analog is always at the top and does not move down... it moves to the left and right, but it does not go down as shown.

I even tried another new analog again but the problem is there again

Can anyone help me? I will be very grateful....the purchase  DS4 cost is too high for me

https://drive.google.com/file/d/1j_dBZpToTsok9LjzQWUC4Ji6V8mpTwjb/view?usp=sharing

https://drive.google.com/file/d/1ZtdyOuB_T690sQhQYRk68xy_bGeNlM-q/view?usp=sharing

https://drive.google.com/file/d/10LRdZgV1CEUx6qXCw38bS9lM98GmabkC/view?usp=sharing



board picture

https://drive.google.com/file/d/1FzD9Gwur4FssshGMyx6aWmieDtcvrH_l/view?usp=sharing

https://drive.google.com/file/d/1r-3vCGFFM9autlIis0hBbH1XNVg1KNSz/view?usp=sharing

[jvcj]

Where are the resistors that are in the analog up and down path? I feel the resistors are damaged
If so, which resistors should I change?

[zis2104]

Where are the resistors that are in the analog up and down path? I feel the resistors are damaged
If so, which resistors should I change?

Maybe you had broke 1 pin on sensor y, remove solder and check

[jvcj]

Thank you..can you explain more?

[jvcj]

I plugged a wire into the hole between the pins..and the analog fit perfectly in the middle with no problems.
But after playing for 10 to 15 minutes, the analog will go up almost  and it will be like before..
Do I have to connect the wire somewhere?

https://drive.google.com/file/d/19RNltqRSjzJEGFmvsvnpOa86ETshUss-/view?usp=sharing

https://drive.google.com/file/d/1f5R2xo1GOWrW55u-OMyBZ4KUK_NtJPre/view?usp=sharing


https://drive.google.com/file/d/13YgBl7EWZ13DdUIS5Zl6lNqOQBsJ2Zkn/view?usp=sharing


After connecting the wire When it is off DS4 for a few hours and I plug it back in, everything is fine.
But after 10 to 15 minutes the problem returns