problem with mounting LM386

[Arioch_76]

Hi , So I Have a problem with red LED end LM386 , the red LED are on all the time , I try with blu LED and my mounting work fine.
 I think the problem is here :
The red LED ask 1.85V and 0.03A , and the blue LED ask 3.5V and 0.02A ....
what can I do to that LED react as it should sound, changing values resistances? but what values I muste take ?
If someone has already been mounting with red LED , thank for giving me the values he used ...

Thanks a lot for your answer 

PS : Sorry for my poor english , I'm a froggy   

[glenng82]

did u use the right resistors? how did u wire it? i used red and had no problems.

[Arioch_76]

I use 30K resistor for pin2 and 191K for pin3 (+/- 1%), I wire it directly on the LM , my mounting work fine with Blue LEd , with red LED nothing happen LED are all the time ON ....

What the voltage of your LED ?

[glenng82]

not real sure never checked just got them and put them in, umm are all wires connected to lm386 good, how are you swapping between blue and red?

[Totonzio]

you use 10 ohm on positive wire led!  red led  working

[Arioch_76]

Thanks but I have already tried to save a resistance of 10 Ohm, 20 Ohm, 60 Ohm .... positive on the base of the LED, but without result.
For the sawp between blue and red , unsolder (??) the red LED and solder the blue LED on the same cable....

[Totonzio]

parallele led blue and one resistence 10 ohm for red led and parallele ! the led blue is 3.5 v the led red is 2.5!  for 191k 0hm i have use a 180 k and potentiometre 100k!