Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => PS4 => PS4 Controllers/PS4 Rapid Fire Controllers => Topic started by: SchwarzerAfri90 on April 11, 2024, 11:44:23 AM
-
Hey everyone,
I got a problem with a BDM-030 after installing hall effect sticks.
The right stick is constantly moving left. I damaged the trace for the up/down movement and fixed that fololowing the advice of RDC to remove solder mask an solder on a jumper.
The problem is that that all the traces for the left/right movememt seem intact, also the vias.
Also the sensor gets his voltage from the other axis via jumper. Also continuity-measured the three legs , the middle leg is neither grounded nor has i visible broken trace.
What could that else be ? The controller was working fine before.
-
Can be closed, was just stupid. New Sticks had shorter legs and the middle via hat a bad solder joint :rofl: