Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => PS4 => PS4 Controllers/PS4 Rapid Fire Controllers => Topic started by: jvcj on January 29, 2024, 08:53:08 AM
-
After replacing the analog, I encountered the problem that the analog is always at the top and does not move down... it moves to the left and right, but it does not go down as shown.
I even tried another new analog again but the problem is there again
Can anyone help me? I will be very grateful....the purchase DS4 cost is too high for me :beg:
https://drive.google.com/file/d/1j_dBZpToTsok9LjzQWUC4Ji6V8mpTwjb/view?usp=sharing
https://drive.google.com/file/d/1ZtdyOuB_T690sQhQYRk68xy_bGeNlM-q/view?usp=sharing
https://drive.google.com/file/d/10LRdZgV1CEUx6qXCw38bS9lM98GmabkC/view?usp=sharing
board picture
https://drive.google.com/file/d/1FzD9Gwur4FssshGMyx6aWmieDtcvrH_l/view?usp=sharing
https://drive.google.com/file/d/1r-3vCGFFM9autlIis0hBbH1XNVg1KNSz/view?usp=sharing
-
Where are the resistors that are in the analog up and down path? I feel the resistors are damaged
If so, which resistors should I change?
-
Where are the resistors that are in the analog up and down path? I feel the resistors are damaged
If so, which resistors should I change?
Maybe you had broke 1 pin on sensor y, remove solder and check
-
Thank you..can you explain more?
-
I plugged a wire into the hole between the pins..and the analog fit perfectly in the middle with no problems.
But after playing for 10 to 15 minutes, the analog will go up almost and it will be like before..
Do I have to connect the wire somewhere?
https://drive.google.com/file/d/19RNltqRSjzJEGFmvsvnpOa86ETshUss-/view?usp=sharing
https://drive.google.com/file/d/1f5R2xo1GOWrW55u-OMyBZ4KUK_NtJPre/view?usp=sharing
https://drive.google.com/file/d/13YgBl7EWZ13DdUIS5Zl6lNqOQBsJ2Zkn/view?usp=sharing
After connecting the wire When it is off DS4 for a few hours and I plug it back in, everything is fine.
But after 10 to 15 minutes the problem returns