Acidmods

Console Modding------ ( Here you can talk about your favorite Consoles ) => XBOX 360 => Tutorials => Topic started by: djaaron on October 16, 2012, 06:22:41 AM

Title: How to make a molex power supply!! and 12v model schematic
Post by: djaaron on October 16, 2012, 06:22:41 AM

Hello all i made this pdf step by step tutorial with lots of pic's to make it noob friendly.
If you still need Help with any thing just ask.
Click Here (http://dl.dropbox.com/u/50185324/MOLEX%20POWER%20SUPPLY.pdf)

12v model schematic diagram.( One with power led's to show the out put power is ok and one with no led's )
CLICK HERE (http://dl.dropbox.com/u/50185324/molex%20pic.jpg) 
Warning this is good for about 1 AMP ok for a ck3 but not recommended brunner max drive!!!!

Thanks Aaron,

Title: Re: How to make a molex power supply!! and 12v model schematic
Post by: cobi_vw on October 16, 2012, 09:08:20 AM

Nice tutorial,  :tup:

Title: Re: How to make a molex power supply!! and 12v model schematic
Post by: Luigus on October 16, 2012, 09:41:52 AM

nice idea man, maybe just check your spelling twice :P

i would definitely think of doing something like this myself.

Title: Re: How to make a molex power supply!! and 12v model schematic
Post by: djaaron on October 16, 2012, 10:37:50 AM

Dude i am dyslexic i'm not the best speller  but i try my best i just hope the people on the forum can over look that and use the useful part of my post.

Title: Re: How to make a molex power supply!! and 12v model schematic
Post by: Nevbox on October 16, 2012, 10:55:10 AM

Note: With some molex cables the metal used in the wire can not be tinned due to the alloy, with this kind of wire you must cut the molex connector up and take out the pins and solder onto them.

Also removing the power connector from the board requires a high wattage iron, because of the high melting point solder used :)