Acidmods

Acid Mods Community Area => Discussion Boards => Beginners Corner => Topic started by: gawl47 on January 27, 2008, 04:50:53 PM

Title: a2d installation help please
Post by: gawl47 on January 27, 2008, 04:50:53 PM

Could someone please tell me using this image:

(https://www.acidmods.com/wiki/pspimg/A2D1.JPG)

which point goes to which button on the a2d board, like starting from the top

1: /\

2: ()

3: ground

4: X

5: []

Title: Re: a2d installation help please
Post by: 4dP on January 27, 2008, 06:54:41 PM

first using a razor 2 board is easier and thinner.

(https://www.acidmods.com/wiki/pspimg/nub2.JPG)

Title: Re: a2d installation help please
Post by: gawl47 on January 27, 2008, 07:40:51 PM

I'm not sure I'm reading that right but it seems to be:

1: O

2: []

3: Ground

4: X

5: /\

is that right?

The power board is already soldered and the faceplate is already cut. So I'm just soldering the wires to the a2d board so I can use the nub.

Is there really any difference in, performance wise, between a razor/2 and a a2d board?

Title: Re: a2d installation help please
Post by: psp_nl on January 27, 2008, 10:38:14 PM

No, only the razor/2 board is thinner, which it can fit internally in the faceplate. The A2D can not.

Title: Re: a2d installation help please
Post by: 4dP on January 27, 2008, 11:51:58 PM

oh yes that wiring is correct