Acidmods

Console Modding------ ( Here you can talk about your favorite Consoles ) => PSP's => PSP Phat (1000) => Topic started by: dennisrr on March 31, 2008, 01:51:36 AM

Title: Mulitple Switch Activated LED's Question
Post by: dennisrr on March 31, 2008, 01:51:36 AM

Is it possible to wire more than 2 LED's to the hold switch?
Reason I'm askin is cause I don't wan't em to always be on and I'm thinkin bout adding more LED's since I only got 2 on my triggers. (Hold switch)

Title: Re: Mulitple Switch Activated LED's Question
Post by: sprocketme2 on March 31, 2008, 05:35:05 PM

Yes. Simply connent the negative wire of every LED you install to the Hold switch pin and that should work. However you will not have mods (led1 one led2 off) all the leds will either be on or off.

Title: Re: Mulitple Switch Activated LED's Question
Post by: GhoSt on March 31, 2008, 10:11:32 PM

the simple anwser yes :tup:

Title: Re: Mulitple Switch Activated LED's Question
Post by: dennisrr on April 04, 2008, 01:12:28 AM

Quote from: sprocketme2 on March 31, 2008, 05:35:05 PM

Yes. Simply connent the negative wire of every LED you install to the Hold switch pin and that should work. However you will not have mods (led1 one led2 off) all the leds will either be on or off.

Woo.
Makes me feel a lot better.
Of course I use the exact same circuit right? Resistor and all? Just a different positive point?