Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => PSP's => PSP Phat (1000) => Topic started by: Sgt Lovin on May 18, 2008, 08:58:17 AM
-
Ok, here's the Problem:
My Coolmods clear case doesn't fit very well with all my PSP parts, the motherboard off a little to the right and the screw for it wont go in.
once i put together my PSP, i tried turning it on it but it wouldn't turn on, so i pished the power switch in and up and what do you know it lit up. But once i turned it on the green power LED would start fading away, so put pressure on the PCB board and the green LED got brighter.
Ok, once all of the above was done, i put the LCD brace and it fit very well, but when i tried putting the faceplate it wouldn't close from the top right corner, i got the top left corner of the PSP to close by putting some good pressure on it and it did, but i was scared of breaking the right side.
Any one had this problem with the clear case before?
Any info would be appreciated, Thanx
-
yeah, I hate installing those clear cases, they need so much cutting its not even funny