Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => PSP's => PSP Phat (1000) => Topic started by: rceckspurt13 on June 21, 2008, 09:33:59 PM
-
First of all before i go any further, i realize that this will require alot of work if someone decides to do it but it would be really cool. As far as i know, im the first one to post an idea like this.
Some people have put the mem stick indicators into the triggers, but my idea is to put all of the indicators into the triggers. I Put a picture below to show what i mean. Since all of the LEDS are so small, you should be able to fit four of them into a single trigger. Unlike the single led trigger mod where you drill a single hole, for this you would either have to drill four small holes, or cut a slot along the bottom of the triggers for the leds to sit into. Although the picture only shows the right trigger, obviously it would be duplicated on the other side. Also if you wanted to be able to turn the leds off, the positive or negitive side of all of them could be connected to one switch ,such as the hold. I belive this could be done. Let me know what you think.
Picture:
(https://acidmods.com/forum/proxy.php?request=http%3A%2F%2Frceckspurt13.googlepages.com%2FDSCN1278.JPG%2FDSCN1278-full%3Binit%3A.JPG&hash=9c466138b1e0c5c1bf0229871bf29d16744128af)
-
sounds cool i like the idea go on and do it
-
easy enough but idk about how your going to put the leds in the triggers the diagram might have to change when you are modding you have to think about space
-
Space would be a issue, Why not split them so you have two in each trigger
-
I did think about space as an issue. But as the picture below shows, there should be plenty of room to the left and right of the gray rubber thing for the leds as small as they are. Also as i said, if you cut a notch into the bottom of the button, you could even put leds right above the gray thing.
Picture:
(https://acidmods.com/forum/proxy.php?request=http%3A%2F%2Frceckspurt13.googlepages.com%2Frbuttoncaseopenhp7.jpg%2Frbuttoncaseopenhp7-full%3Binit%3A.jpg&hash=0122efbb054c0770d1b8d4ca5e28cc4617bd9381)
-
If you put LEDs there, you would have trouble pushing the triggers.
-
just drill two holes and put two leds in each hole,still that is a bit of a bundle of wires to have in you buttons and not have it make it harder to press but still a good idea
-
they make some pretty small wire. You could probably find some that won't be big enough to interfere with the button.