Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => XBOX 360 => 360 Controllers / 360 Rapid Fire Controllers => Topic started by: SpartanXx666xX on August 11, 2008, 01:01:54 PM
-
Okay, well i got my rapidfire kit that i bought from the site yesterday and i started on one of my old controllers and i was following the diagram from the tutorial and everything soldered eveything just fine and .......
then i tried it and it worked so i wanted to put the case back on and i tried it one more time before i did and it didnt work, and it hasnt worked from them on.....ive tried it the sleeper method (no switches) since thats what i wanted cause its easy to do.
Someone i talked to said I might have fried the chip, if thats a possibility please lemme know how i can check and make sure that i did or did not :beg:
Also, in those 10 seconds that it did work ive noticied something unusual, instead of takin one push to the sync button to active rapid fire it took 3 or 2 just random number of times. :dntknw:
Any ideas, suggestion, comments, questions, replies are all greatly appreciated .
:confused:
-
i think you may have fried the chip...try it in another controller see if it works...
-
i think you may have fried the chip...try it in another controller see if it works...
do you know any other way i can check to see if the chip is working??
-
put it in a PIC Programmer i think and if anything try on another controller or check if all the wires are still soldered or there still in place
-
Thanks for your help, i was able to get a hold of mike and i talked to him about it, so i shouldnt have any big problems.
Appreciate your help