Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => XBOX 360 => 360 Controllers / 360 Rapid Fire Controllers => Topic started by: m@DDm!k3 on August 25, 2008, 05:38:23 PM
-
unlike everyone else that mod accually worked out for me but recently i resprayed my controller and had to resold my button to the r trigger again since button is permanetally in case now when i re-soldered it dont know wut happen but my r-trigger or rapid fire button dont work anymore i checked and it was a clean solder nothing was touching each other or exposed plz help if you can :greedy: :greedy: :greedy:
a million thx
-
If you have a volt meter or continuity checker. Check the switch. If you have a volt meter, set it on ohms and when the button is pushed it should read 0.00, if you have a continuity checker it should have continuity when pressed. Alot of volt meters have a continuity checker built in as well. When you re-painted the controller paint may have gotten into it and is not allowing the switch to make contact inside. You may be able to clean it with alcohol or nail polish remover. Be careful with either one as they can damage your paint job. If the switch is ok. Then check continuity on the wires. To make sure the didn't break internally while you were removing or replacing them. The solid core wire is more apt to break than stranded. But it's hard to get stranded that small and work with it.
-
thx a bunch man i try this as soon as i get home (im at school lol :laughing:)
-
how do i get it