Acidmods

Console Modding------ ( Here you can talk about your favorite Consoles ) => XBOX 360 => 360 Controllers / 360 Rapid Fire Controllers => Topic started by: dansterdan on September 10, 2008, 08:18:48 PM

Title: rapid fire issue
Post by: dansterdan on September 10, 2008, 08:18:48 PM

 did whole thing all works but when put case back on and screw in right and top left but after that if i screw any more it just makes Lt action on. only when gets to certain point. give some advice please. (https://acidmods.com/forum/proxy.php?request=http%3A%2F%2Fimg46.imageshack.us%2Fimg46%2F3238%2Fpic0583js8.th.jpg&hash=d6b8655d985840399b0eab91303ed8e618e9b004) (http://img46.imageshack.us/my.php?image=pic0583js8.jpg)

Title: Re: rapid fire issue
Post by: Skullmaster on September 10, 2008, 08:21:42 PM

More than likely a wire is pinched making a short

Title: Re: rapid fire issue
Post by: dansterdan on September 10, 2008, 09:30:47 PM

could be ill check that. IT piss me off though because it works and then right as I screw it in tight it Wont stop its like holding the LT down. but Lt is up.

Title: Re: rapid fire issue
Post by: KingMike_OS on September 11, 2008, 12:18:28 AM

Who's Kit is that .. not ours .. Hmm Looks like ebay kit.  ???

Title: Re: rapid fire issue
Post by: Hazer on September 11, 2008, 02:43:56 AM

That resistor looks like it is in the way of the Dpad. It may be gettiing pushed to one of the vias.

Also, one of your power wires has way too much bare wire showing and looks like it also could be pinched by the Dpad.

Title: Re: rapid fire issue
Post by: Winterz117 on September 11, 2008, 04:14:54 AM

yeah hazer is right it looks like you need to move the resistor a bit, just bend it up towards the analog stick.

Title: Re: rapid fire issue
Post by: dansterdan on September 11, 2008, 08:06:59 AM

I ll move the resistor and see if that dose the trick

Title: Re: rapid fire issue
Post by: blackburn on September 11, 2008, 06:08:42 PM

yeah like others have said the only real issue i can see is the resistor....  i doubt this could be an issue, but some of the soldering is a bit thick (large beads) and it could be causing a shot but i cant really think of anything that it could touch.  :dntknw: I would just try moving the resistor first  :victory:

Title: Re: rapid fire issue
Post by: blackburn on September 11, 2008, 06:09:12 PM

Quote from: blackburn on September 11, 2008, 06:08:42 PM

yeah like others have said the only real issue i can see is the resistor....  i doubt this could be an issue, but some of the soldering is a bit thick (large beads) and it could be causing a short somewhere but i cant really think of anything that it could touch.  :dntknw: I would just try moving the resistor first  :victory:

Title: Re: rapid fire issue
Post by: dansterdan on September 11, 2008, 06:43:08 PM

Thank you guys i fixed the problem it was partly the resister and the rumble was making the button touch other side.