Acidmods

Console Modding------ ( Here you can talk about your favorite Consoles ) => Legacy Consoles => PS2 => Topic started by: sakobatoneko on September 30, 2008, 08:38:55 PM

Title: black screen
Post by: sakobatoneko on September 30, 2008, 08:38:55 PM

my ps2 is showing a black screen when ever i turn it on, it also doesn't let me eject games. This all happened after trying to modify it, i googled and they said i need a new chip called BA5815FM. anybody know whats wrong?

Title: Re: black screen
Post by: Blizzrad on October 02, 2008, 12:58:56 PM

A few questions for further diagnosis:

1: Is the green power light turning on when you power on the console?
2: Does the disc drive jam when the eject button is pressed, or does it not respond at all?
3: Is there a game disc stuck in the console?

I think the BA5815FM is the motor control IC for the DVD drive, and as far as I know the Ps2 should still boot into the BIOS fine with a defective or absent DVD drive.

Title: Re: black screen
Post by: sakobatoneko on October 02, 2008, 03:22:17 PM

the green power light turns on and so does the console.
it doesnt respond at all
there is no game in the console.

Title: Re: black screen
Post by: Blizzrad on October 04, 2008, 06:01:44 PM

A couple more questions:

1: What sort of modification did you make to the Ps2?
2: When you say "black screen," do you mean that the Ps2 outputs a full black frame, or that it outputs no audio/video signal at all?

If this happened after installing a mod-chip it could be due to incorrect wiring, beyond that though I am not really sure, there are many potential variables. It seems odd that a faulty motor driver IC would keep the whole thing from booting properly. Maybe this causes it to fail some security check?

Title: Re: black screen
Post by: sakobatoneko on October 04, 2008, 09:05:40 PM

it was a mod chip, and when i was installing it a blob of solder got on a few pins on a ic. i took the solder off with a desolder but still the black screen comes up. It displays a black screen and no audio, but my mod chip shows its configurations when i hold the buttons to go to it.

Title: Re: black screen
Post by: Blizzrad on October 05, 2008, 08:14:53 PM

If you accidentally bridged some pins on the BIOS chip during installation, this could be the source of the problem. If you haven't already, use a multimeter to check all of the pins around your solder points, particularly the area where the solder went astray. Use the continuity/resistance setting to ensure that none of the pins are bridged.

Title: Re: black screen
Post by: sakobatoneko on October 10, 2008, 06:14:14 PM

ok i took off all the solder that was left and i still get a black screen.