Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => XBOX 360 => 360 Controllers / 360 Rapid Fire Controllers => Topic started by: chrssk8534 on October 19, 2008, 04:37:00 PM
-
hey
i just got the dual rapid fire kit in the mail with the wires presoldered
but i saw in the picture in a rapidfire thread that i only need to use 4 wires
there are six presoldered on mine
which ones do i take off?
and im still confused where i solder the wire to for the sync button (in the picture it was like SW13)
any help would be appreciated
-
tut is here : https://www.acidmods.com/forum/index.php?topic=21452.0
now, you must decide which options you are going to do it sounds like you want the diagram labled "sleeper CG dead bug power save mode" (this is the one I did) follow the diagram, any extra wires snip off.
as for the sinc button. you only use one of the two points shown in yellow. I used the center pin of the sinc button. the SW 13 pissed me off and I went to sinc instead. it was not hard, apply a small amount of solder to the bare end of the wire first, then solder. should only take a second. dont over heat.
-
ok
thanks man
you cleared it up for me
-
you don't need white or long blue wire .. you can keep it or cut it what ever you like ..
white is left trigger on/off .. and long blue is lef trigger ..