Acidmods

Console Modding------ ( Here you can talk about your favorite Consoles ) => PSP's => PSP Phat (1000) => Topic started by: juust0_ on February 14, 2009, 08:51:04 AM

Title: Bridged powerboard led resistors?
Post by: juust0_ on February 14, 2009, 08:51:04 AM

So, what happens if i bridge those resistors or remove them and add solder to connect the pads? Does the leds even work or does they handle the voltage? I have blue power and red charge.

Title: Re: Bridged powerboard led resistors?
Post by: pspupgrade on February 14, 2009, 09:03:47 AM

When you bridge the resistors, you will also need to solder the appropriate resistor to your LED to stop it from blowing. Then the LED should be brighter but won't blow.

Title: Re: Bridged powerboard led resistors?
Post by: juust0_ on February 14, 2009, 01:04:29 PM

What if id change those resistors to 10ohm would leds become brighter? How many ohms are those stock ones?

Title: Re: Bridged powerboard led resistors?
Post by: psp339 on February 14, 2009, 11:03:08 PM

I bridged the power resistor and swapped the LED to blue and now it's super bright.

Title: Re: Bridged powerboard led resistors?
Post by: GhoSt on February 14, 2009, 11:21:05 PM

tut https://www.acidmods.com/forum/index.php?topic=27427.0 (https://www.acidmods.com/forum/index.php?topic=27427.0)