Acidmods

Console Modding------ ( Here you can talk about your favorite Consoles ) => XBOX 360 => 360 Controllers / 360 Rapid Fire Controllers => Topic started by: Fire Thorn on March 04, 2009, 05:44:11 PM

Title: Help with the dual rapid fire mod.
Post by: Fire Thorn on March 04, 2009, 05:44:11 PM

Can someone tell me how to make the player 3 and 4 leds light up when i push the on switches for the rapid fire. the mod i performed is in the link below.

http://i167.photobucket.com/albums/u136/kingmike_001/DEADBUGMATRIX1.jpg

Title: Re: Help with the dual rapid fire mod.
Post by: ichagowill on March 06, 2009, 02:31:14 PM

maybe you should solder a wire to the 4 player and test it by getting the other end and pressing it to each pin. 

Title: Re: Help with the dual rapid fire mod.
Post by: Modded Matt on March 09, 2009, 05:28:08 AM

this chip is not set up to do that.

conect a wire from the output of the chip to the led. this is going to cause the led to pulsate, and it wont be very bright, but I think it will do what you are asking.

you could also add a on/off toggle switch, with led, to the main power source of the chip.  check your supply and use a resistor