Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => PSP's => PSP Slim (2000) => Topic started by: roshurwill14 on March 28, 2009, 09:32:44 AM
-
hi u know the powerboard on the psp 2000 slim and lite how much is the output in voltage is it 3.6v or 5v? and for the leds do u use the 0603 leds or a normal one i need 2 green leds for my triggers....
-
The output is less than 3v for the power/charge leds and you need 0603 leds.
-
The output is less than 3v for the power/charge leds and you need 0603 leds.
so if i had two 0603 leds would that board keep them the same brightness or would i need a resistor?
-
Well it depends how much forward voltage is needed per led. Some higher voltage ones will be dim but lower voltage ones will be fine. Either way you wont need a resistor.
-
so just two 0603 0603 leds will be fine and quite bright?
-
eh, not necessarily. Blue, white, and i think a few others will be sorta dim. Green, orange, and red will be fairly bright.
-
so u think i should get blue are they brighter then?
-
...um
eh, not necessarily. Blue, white, and i think a few others will be sorta dim. Green, orange, and red will be fairly bright.
-
hi u know the powerboard on the psp 2000 slim and lite how much is the output in voltage is it 3.6v or 5v? and for the leds do u use the 0603 leds or a normal one i need 2 green leds for my triggers....
Hey there m8
i would recommend you do a transistor mod and pull power from something other than the SMD transistors on the psp unit. i use a PNP TO92 transistor driven direct from the power light smd transistor with a 10ohm resistor from collector to Batt pos.
Hawk