Acidmods

AcidMods Resources ----- ( These are helpful tools for modding ) => Open Source Code & AcidMods Free Code => Topic started by: xSLICKVICx on April 15, 2009, 06:49:37 PM

Title: burnmeup 2 not working on matrix controller
Post by: xSLICKVICx on April 15, 2009, 06:49:37 PM

Hi i installed hazers code exactly as the diagram showed but the rapid fire is always on and it dont change modes any reason why?

Title: Re: burnmeup 2 not working on matrix controller
Post by: Hazer on April 15, 2009, 07:46:57 PM

One of two things:

1: did you wire the chip with the legs facing down so the notch is facing up as in the diagram?

2: If so, then replace the resistors going to the triggers with 1000 Ohm resistors and see if that works.

Title: Re: burnmeup 2 not working on matrix controller
Post by: treemty on April 15, 2009, 08:16:49 PM

I already helped him, he used wrong resistors

Title: Re: burnmeup 2 not working on matrix controller
Post by: Modded Matt on April 16, 2009, 04:28:46 AM

I probably should have take the rapid on buttons out of the tut. I can see now people wiring it without resistors, and without the push buttons and getting an auto fire problem. I was kindof expecting this. LOL