Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => XBOX 360 => 360 Controllers / 360 Rapid Fire Controllers => Topic started by: pm666drummer on April 21, 2009, 06:56:47 PM
-
hey i have both of them, one of them installed already in a controller, the other just sitting around. is the CG board from the old shop the same as the matrix? i know the matrix has the surface mount resistors and the cg doesnt. like could i just put the right resistors on the cg board to make it work with a matrix controller or do i have to wait til all this shop rebuilding crap gets fixed?
-
yah, the spots for the parts are on the board, you just need to get the parts and install them. hmm let me see if I can remember.......
(3) mmbt3904 (sot23 size)
(3) 0805 size 1.5Kohm resistors
(1) 0805 size 470 ohm resistor
that is for if the RR is on the installed push button. The chip is the same for both versions, the hardware is all that is different. take a look at the install guide for proper installation and let me know if you have problems.