Acidmods

Console Modding------ ( Here you can talk about your favorite Consoles ) => XBOX 360 => 360 Controllers / 360 Rapid Fire Controllers => Topic started by: KRAY0N on June 20, 2009, 05:36:53 PM

Title: Kynar Wire Help
Post by: KRAY0N on June 20, 2009, 05:36:53 PM

Whats the best way to strip 30 gauge kynar if you dont havea striping tool for that thin of wire?

Title: Re: Kynar Wire Help
Post by: Modded Matt on June 20, 2009, 05:38:42 PM

fire

Title: Re: Kynar Wire Help
Post by: the360modder on June 20, 2009, 05:40:05 PM

use a x-acto knife, or a x-acto knife that was in a fire, which is better.

Title: Re: Kynar Wire Help
Post by: W-Gaming5 on June 20, 2009, 10:55:30 PM

 :censored: :censored: :censored: :censored: :censored: :censored:

Title: Re: Kynar Wire Help
Post by: ichagowill on June 21, 2009, 03:03:04 AM

sometimes when i mess up and have to replace the button and dont have enough room to strip the wire i melt it down with the solder

Title: Re: Kynar Wire Help
Post by: Modded Matt on June 21, 2009, 06:06:38 AM

sory about the answer abvoe I was a bit out of sorts last night. I use a cigaret lighter to just melt back the tip, thus not exposing too much wire, you allways want to keep those bare spots as small as posible, if you need a larger exposed end for a splice use an exacto knofe tro skin one side then hit it with the lighter to melt back any frays, if you need a cut inline splice its the same princble, slice off piece of wire with exacto, and heat with iron if you cant get the lighter where you need it.

Title: Re: Kynar Wire Help
Post by: Frankie.R on June 22, 2009, 12:29:17 PM

I use my teeth. Don't have money to spend on wire stripper's.  :victory:

Title: Re: Kynar Wire Help
Post by: laxboy on June 22, 2009, 01:38:32 PM

lol havent hurd that before  :drunk: :huh:

Title: Re: Kynar Wire Help
Post by: gamerdude767 on June 22, 2009, 02:29:21 PM

yup, i use my teeth if i don't have a lighter or pair of scissors near me..