Acidmods

Console Modding------ ( Here you can talk about your favorite Consoles ) => PSP's => PSP Slim (2000) => Topic started by: Ben93 on November 08, 2009, 11:02:54 AM

Title: Replace ms led with rumble motor?
Post by: Ben93 on November 08, 2009, 11:02:54 AM

Hi guys

Is it possible to replace the MS led with a rumble motor so the psp will rumble while files are loading? What's the voltage at the ms led?

Tnx

Title: Re: Replace ms led with rumble motor?
Post by: FaT3oYCG on November 08, 2009, 11:06:13 AM

use a multimeter?

Title: Re: Replace ms led with rumble motor?
Post by: Ben93 on November 08, 2009, 12:27:15 PM

I should buy one, i know.
But, let me think, if i bridge the resistor => the led gets a lot brighter => 5 (4.9)V is going to the led...
So the only question that's left: will it work?

Title: Re: Replace ms led with rumble motor?
Post by: matv90 on November 10, 2009, 06:20:24 PM

it would not run well because the current in the leds are very small, also you can burn the led when the motor rumble.

Its better to put a transistor as in the light mods, just check the polarity of the led and wire as if the led was the speaker

Title: Re: Replace ms led with rumble motor?
Post by: Ben93 on November 11, 2009, 07:33:49 AM

I'm not english, what do you mean with "the current"?

I tried a few hours ago, led removed, wired up the motor, does rumble, but very soft. I can't get it harder by bridging the reistor underneath the led, on the other side of the mobo also?