Acidmods

Console Modding------ ( Here you can talk about your favorite Consoles ) => XBOX 360 => Tutorials => Topic started by: Modded Matt on December 15, 2009, 08:44:19 AM

Title: bumper lighting by spurgurgle
Post by: Modded Matt on December 15, 2009, 08:44:19 AM

Post Merge: December 13, 2009, 02:19:29 PM
bumper lighting



Introduction
In this section i will be showing you a simple way to ad bumper lights
to your transparent bumpers.

Parts Needed


Tools Needed


Difficulty rating: 3/5


Average Time to Complete: i.e 10-20mins


Notes:
be carefull soldering the 0603 leds as to much heat can damage them.
 
Step By Step Tutorial
1- solder your 0603 to the - contacts on the bumper buttons... the pad im using is a cg but this may be different for matrix so check it before hand

(https://www.acidmods.com/RAND/upload/files/upload/bumper_led1.JPG)

2- now bridge the 2 + contacts on your leds with a legth of wire

(https://www.acidmods.com/RAND/upload/files/upload/bumper_led2.JPG)

3- now run a wire from the right leds + contact to either the + contact on the breadboard installed during the dome lighting tutorial or to the + contact shown inthe  picture below.

(https://www.acidmods.com/RAND/upload/files/upload/bumper_led3.JPG)

test and close up.
(https://www.acidmods.com/RAND/upload/files/upload/bumper_led4.JPG)

FAQ/ Troubleshooting




SimplePortal 2.3.5 © 2008-2012, SimplePortal