Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => PSP's => PSP Slim (2000) => Topic started by: cboy_6060 on January 27, 2010, 04:36:59 PM
-
I have a psp slim (2000) that i would like to put some leds in but im not sure where to solder the wires on the power board. i was thinking to the green led - and the 4.9v ...can someone please tell me if i am right or correct me if i am wrong. any help would be appreciated.
Thanks,
Cody :drunk:
-
The resistor near the memory card LED is a good power source. If you want sound reactive, just solder to the speaker pads
-
https://www.acidmods.com/forum/index.php/topic,28601.0.html (https://www.acidmods.com/forum/index.php/topic,28601.0.html) (take no credit for diagram)
always use the searc first ;P
-
The resistor near the memory card LED is a good power source. If you want sound reactive, just solder to the speaker pads
where should i run the - wire to then. sorry im kind of new to this whole thing.. thanks for all the help guys
-
solid led:your negative wire will go from your switch (wifi, hold, another switch) to your negative wires from the leds.
sound reactive: with an lm386 theres 3 negatives or more if u have mor eleds. 1 from the chip, 1 from the switch and 1 - unlimited -wires from yoru leds. Direct contact. positve and negative wires run to the + and - poles on the speaker. then you add another negative wire to the bunch of negative wires on the speaker and hook that wire to your switch
-
thanks guys for all your help :hifive: