Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => PSP's => PSP Phat (1000) => Topic started by: xMEx on May 19, 2010, 12:31:17 PM
-
Well I found my multimeter so I could check my psp backlight fuse worked so I tried to check it and I ended up on every single setting and I just wanted to make sure I was doing it right.
It was like this.
---{FD}---
---{FD}---
the color is positive and negative probes from my multimeter.
and the needle never moved at all and I used it on my AA battery and the needle moved so that means my multimeter worked but my fuse dosn't work right?
and just to clairify when I touched the battery with the probes the needle moved and when I touched either side of the fuse the needle stayed still.
And should I bridge my fuse or should I try to replace it?
-
you have to test for power in relation to ground. meaning you hold the black probe on a ground point and use the red to test each side of the fuse, while holding the black on a ground point. the psp must be on.
or
simply test the fuse for contenuity. this is a test to make sure the fuse is connected all the way through. there is a setting on your meter for this, touch your two probes together the meter should make a beep sound. touch one probe to each side of the fuse if the meter beeps, the fuse is good if it don't, the fuse is bad.
-
Where is a ground point on a psp?
-
dude, your going to have a hard time.
in this pic, you see the power plug, it has two points where it contacts the mobo, the positive has a red wire soldered to it, the ground does not
(https://www.acidmods.com/JR/USBChargeMod/DSC00066.jpg)