Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => XBOX 360 => 360 Controllers / 360 Rapid Fire Controllers => Topic started by: fragged3d on May 27, 2010, 09:18:58 AM
-
Been a while since I've been here! I have gotten a nice station setup going and I'm getting more and more into the modding.
I would like to know if there is a tut somewhere that shows the correct position to light xbox 360 controller buttons?
Also, I have never used 0603 leds, how do you tell which side is pos and which is neg?
Thanks,
Ryan
-
Here you go. This is the childboard for the xbox controller tutorials. Spurgurgle did a good number of tutuorials on how to light the controller. https://www.acidmods.com/forum/index.php/board,425.0.html (https://www.acidmods.com/forum/index.php/board,425.0.html)
welcome back =)
-
Ok, I get the gist of everything but why would the vdd point run constant?
-
it depends on the controller.
-
It's a matrix type.
-
the controller does not shut off you will need to buy a optocoupler
-
The controller shuts off but when there is an led hooked to the ground and vdd the led shines constant.
-
yes that is the thing with a matrix the power will still remain constent when the controller is off you need to put a optocoupler in the controller.
-
Is there a specific model and is there a tut on how to use them?
Post Merge: June 01, 2010, 10:05:31 AM
Found the tut but no model number. The ones I'm looking at are advertised EL817 PC817 Optocoupler IC