Acidmods

Console Modding------ ( Here you can talk about your favorite Consoles ) => PSP's => PSP Slim (2000) => Topic started by: mario_99 on June 29, 2010, 11:44:57 PM

Title: psp 2000 need help
Post by: mario_99 on June 29, 2010, 11:44:57 PM

i  :censored:up my psp while trying to put the LCD back in the zif connector for the LCD broke like 1 pin broke i need help on how to solder a new one or if some one could do it for me and how much would you charge.

Title: Re: psp 2000 need help
Post by: nEoVaLoR on June 30, 2010, 02:20:40 AM

Its hard to solder a zif connector back in. If anyone does try this I wish you goooooood luck!!!

Title: Re: psp 2000 need help
Post by: mario_99 on June 30, 2010, 03:06:12 AM

how much is this motherboard worth it has custom firmware i dont know if that matters or not

Title: Re: psp 2000 need help
Post by: nEoVaLoR on June 30, 2010, 06:55:19 AM

Quote from: mario_99 on June 30, 2010, 03:06:12 AM

how much is this motherboard worth it has custom firmware i dont know if that matters or not

The value has decreased now. They normally go for $60. It would probably go for about $10-$20.

Title: Re: psp 2000 need help
Post by: mario_99 on June 30, 2010, 01:41:31 PM

im going to sell it on ebay if i could.  That  :censored: sucks im gonna have to buy another one

Title: Re: psp 2000 need help
Post by: nEoVaLoR on July 01, 2010, 04:47:00 AM

Yea unless you can take the pin off solder a wire and run it exactly like the pin. But it would be really hard. Don't reccomend to the unexperienced.

Title: Re: psp 2000 need help
Post by: mario_99 on July 01, 2010, 05:52:53 AM

i rather save the time and buy a new one it seems very hard to do since the pins are very small