Acidmods

Console Modding------ ( Here you can talk about your favorite Consoles ) => XBOX 360 => Topic started by: PAIN IS AWESOME on November 03, 2010, 02:13:59 AM

Title: ROL Xbox Controller Help!!!!!!!!
Post by: PAIN IS AWESOME on November 03, 2010, 02:13:59 AM

I was putting different leds into my controller and i accidently pulled off both pads for number 2 led how could i solder this on as i have tryed and failed horribly

Title: Re: ROL Xbox Controller Help!!!!!!!!
Post by: whitetop on November 03, 2010, 04:18:03 AM

i had this on led 1 just follow the middle trace on the board from the led you will find a pin hole solder some wire to them then your led bet make sure it works before soldering to the pad

Title: Re: ROL Xbox Controller Help!!!!!!!!
Post by: PAIN IS AWESOME on November 04, 2010, 12:09:14 AM

Thanks I also Found on my matrix i can solder a wire from a vdd to the positive of the led and ground it on the wire and works still thanks again