Acidmods

AcidMods Resources ----- ( These are helpful tools for modding ) => Open Source Code & AcidMods Free Code => Topic started by: manwinder on February 27, 2011, 08:37:14 AM

Title: USB pic Prgrammer
Post by: manwinder on February 27, 2011, 08:37:14 AM

i  bought a pic programmer off ebay, it has usb. I installed the drivers and i tried to program a pic12f683 with robbo jitter mod, and when i open the hex file it shows all of these #'s, when i erase the chip and program it, and verify, it completes with no errors, but when i read the chip all it shows are 0000. I have programmed pic12f629, and it got programmed properly except for eerom data, in it there are all 0000, the pictures of the hex code and software running are below, should i use a different pic

Title: Re: USB pic Prgrammer
Post by: Anonamous on February 27, 2011, 09:01:43 AM

When I read my pic12F683 after programming it it comes up with all 0000 also. Its supposed to do that. It should be fine. But since your using a pic12F629 I cant be 100% sure.

Title: Re: USB pic Prgrammer
Post by: crazy-modder on February 27, 2011, 09:04:12 AM

That's because you guys have read protect enabled. Disable that if you want to see the hex that was written to the chip.

Title: Re: USB pic Prgrammer
Post by: manwinder on February 27, 2011, 03:30:00 PM

what is read protect enabled, is it under the fuse settings, if it is then what is the name of the setting, and i am using both pic12f629 and 12f683

Title: Re: USB pic Prgrammer
Post by: k0mpresd on February 27, 2011, 03:38:08 PM

should be under config bits.

Title: Re: USB pic Prgrammer
Post by: Modded Matt on February 27, 2011, 04:23:16 PM

what are you doing to ask?

Title: Re: USB pic Prgrammer
Post by: staticvoid on February 27, 2011, 10:03:29 PM

just did one yesterday if it says programmed successful its good to go.

Title: Re: USB pic Prgrammer
Post by: EasyE on April 30, 2011, 03:10:32 AM

Manwinder turn off CP in the settings of winpic and see if that helps it worked for me