Acidmods
AcidMods Resources ----- ( These are helpful tools for modding ) => Pic Programmers and Programs => Topic started by: Dcofer on April 12, 2011, 11:54:58 AM
-
So I bought this programmer a few years ago for class and was planning on using it to program my chips with Top's rapidfire code. It is supposed to be a stand in replacement for the Picstart+ programmer however when I try and select it in MPLab the option for Picstart+ is grayed out.
As far as I know I have the latest firmware for the board. I am also running MPLab v8.61.
EDIT: here is a link to the programmer I have http://www.olimex.com/dev/index.html (http://www.olimex.com/dev/index.html)
-
if the device you have selected in MPLAB isnt supported by that programmer it is greyed out.
what device do you have selected? (Configure>Select Device)
-
Currently nothing is selected, I know I have programmed with this programmer before but it has been 3 years or so so MPLab has gone through a few updates. The option is in the list though I just cant select it.
Got it, thanks haha, I was still lookin for programmers for my 18f45k20 instead of the 12f683 thanks
____________________________________________________
Ok so I put in one of my 12f's and programmed it with tops code and checked it and got this result when I verified the programming:
/////////////////////////////////////////////////////////////////
Programming/Verification completed successfully
PICSTART Program\Verify Report
12-Apr-2011, 12:21:32
Device Type: PIC12F683
Address Range 0-782
Data Memory Errors
Address Good Bad
0000 007F 0001
0002 007F 00FF
/////////////////////////////////////////////////////////////////
Im not really sure what this means, does this mean it did not program correctly?
-
yes it programmed correctly
-
sweet, yeah it has been so long since I used this programmer that I couldnt remember what it was supposed to output