Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => XBOX 360 => Topic started by: Rodent on April 19, 2011, 11:02:06 PM
-
I have recently purchased a xbox 360, It had the RROd, and thought no big deal to fix to get it up and running , so I Fixed the RROd, and put it back together and started it up , and still had the RRod , with ERROR 0001 flashing, so I started to check things over voltages and missing parts then after a few hours I started to google the problem and heres what I came Up , Not sure yet if its my problem, but thought it would be useful to AM.
http://suhastech.com/xbox-360/fix-0001-0002-errors-on-your-xbox-360/
-
yeah before you go ahead and swap mosfets and go crazy just just some simple resistance checking by desoldering the small pins first and checking drain to source should be high resistance ether polarity, gate to source + to - respectively should be high resistance. that will check out the mosfet to be OK. (to save some money in the future).
dont measure anything else or you could kill the mosfet, do a bit of searching and finding of which pins are what on the mosfet. remember drain gate source, just like collector base emitter.
-
Thank you Fookz for the info
I was checking the voltages on one of the mosfets ,and shorted one out so now I have to replace that one so i can go one checking other things, simple mistake. turned my head for a second and everything shut down on 12volt side. leds on the Rol where still on. :censored: happens, just gotta fix it now.
Edit:Ok so now i have checked mosfits, changed out the bad ones still had the 3 red rings error ooo2 still.
so now I changed the controller chip on the bottom of the board like it said and no the whole 12 volt side I have nothing, 5 volts good 3.3 volts good and 1.8 volts are good and got some stupid error 0031, dont have a clue what it is. so must be voltage regulator that is bad or something , turns on then spins the fans and shuts off,. guess this just became a parts box...lol
was worth a shot.