Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => PSP's => PSP Phat (1000) => Topic started by: zephyr1220 on April 27, 2011, 07:02:48 PM
-
Just finished installing 8 red leds using 2n2222 last night.
I encountered something, at the start up lights are at their dimmest light but i was expecting that if music came they will shine the brightest but instead they went off totally and never came back.
When i put it to hold mode and turn it on again they are at they dimmest then same thing happened when i play music they went off.
What could it be? i am using 500 ohm resistor for all eight, i hope someone can help me.
-
a 500 ohm resistor is way to high! try replacing it with a lower one like 100 or 120 ohm resistor and they will be bright.
-
Something bad went wrong...
I tired replacing the 2n2222 mod with the lm386 coz i thought theres something wrong with my transistor as i finish the mod my psp just turned on and no reaction no start up boot or whatsoever its just on.
I dont what happened can any one help me pls...
My best friend is dying (the psp) HELP!!!
-
sounds like you may have soldered something you shouldnt have or the lm386 chip is toching the bottom of the psp motherboard. did you remember to put electrical tape over the exposed parts?
and if none of those work then take apart your psp completely and check for any damage or bad solderings then if you find no problems you can see put it back together, and see if it works. sometimes it can be a loose part or a bit of metal caught on the board somewhere.
update if it works after.
-
yes sir you are right its touching the copper area and cause a short i think anyway its fixed now thanks for your help really appreciate it!
-
no problem glad i could help. :tup: