Acidmods

AcidMods Resources ----- ( These are helpful tools for modding ) => Open Source Code & AcidMods Free Code => Topic started by: sQs on May 10, 2011, 12:15:18 AM

Title: Someone installed some rapid fire in the new control with matrix2?
Post by: sQs on May 10, 2011, 12:15:18 AM

It may say something about how it works, and if set made ​​as installed in the old matrix, please comment something about

Title: Re: Someone installed some rapid fire in the new control with matrix2?
Post by: hyper999 on May 10, 2011, 07:52:22 AM

kingmike said, in the thread about it being found, that he had tested rf on it and it worked just like it did on the original mx

Title: Re: Someone installed some rapid fire in the new control with matrix2?
Post by: sQs on June 20, 2011, 09:43:27 PM

Someone who is already installed, what point is recommended to take the positive current?,
In the first PCB Matrix, the current taken from a point that is slightly below LT but that point will not appear in PCB Matrix 2, when the current took the same point is taken for CG/CG2 not working properly.
Today and tried to take the current point TP4 that the bottom of the PCB and I to run correctly, do you think could damage the power to take control of this?