Acidmods

AcidMods Resources ----- ( These are helpful tools for modding ) => Open Source Code & AcidMods Free Code => Topic started by: Eazy! on July 17, 2011, 02:20:08 AM

Title: Robbos RF code - Help Needed please....
Post by: Eazy! on July 17, 2011, 02:20:08 AM

Hey there,

I am trying to write this code to a pic 12f683 chip using PICkit2 and everything goes well during the writing process but when I put it in the controller nothing happens when I press the sync button :(
I have tried other chips with different codes and they are all working fine...

I just don't get why it wont work... I think it might be something to do with the way I'm programming it onto the chip???

Any help would be greatly appreciated! Thanks a lot I kinda need this urgently  :beg:

Cheers!

P.S thanks to Robbo and Famas for their hard work

Title: Re: Robbos RF code - Help Needed please....
Post by: Eazy! on July 17, 2011, 02:22:09 AM

Sorry if this sounds like a noob question but what do you actually have to do to get the program on the chip??

I mean It seems that the programming is successfull but whenever I press verify it says it failed at address 0x00000

I press auto import hex + write device and slect Robbos Hex code.... Is this correct? Is this all that needs to be done?

Thanks again

Title: Re: Robbos RF code - Help Needed please....
Post by: Eazy! on July 17, 2011, 07:53:32 AM

Okay please dont worry about it...

I found the problem - Me being stupid and not reading propery!

I wasn't pressing LT and sync to turn on the modd!

Sorry to waste your time

thanks!