Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => PSP's => PSP Phat (1000) => Topic started by: orangelooker on July 28, 2011, 12:55:56 PM
-
Hi guys i've been member for long here and finally decided to try the psp phat USB charging hardmod, i did solder as instructed and as clean as possible, when i tested it went fine i can now charge through my usb chargers or laptop even if my psp phat is off.. but i discovered that the USB connectivity for file transferring now gives error "Connect this system to a PC or PS3 using usb cable" problem...
i tried to search for solutions and i found one about fusibles and says something about the USB fuse or the LD fuse, unfortunately i have a TA-086 board which doesn't look like the one i searched... been trying to look all over that board where that fuse is but i can't seem to find it...
helpon this matter will very much be appreciated. thank you.
-
Most likely, you have connected the first two pins on the usb connector. I would inspect those closely to make sure even the smallest bit of solder isn't in between them I had this same problem when I first did this mod, and this was the cause of my problems.