Acidmods

Console Modding------ ( Here you can talk about your favorite Consoles ) => XBOX 360 => Topic started by: 3D0kassiah on August 08, 2011, 06:08:52 PM

Title: xbox controller help cg2
Post by: 3D0kassiah on August 08, 2011, 06:08:52 PM

well after finally installing robbos jitter mod lol i accidently scraped off the y trace i think now the y button dont work any help?

kinda blurry but u get the idea

Title: Re: xbox controller help cg2
Post by: Rodent on August 08, 2011, 06:39:42 PM

Traces
https://www.acidmods.com/forum/index.php/topic,34543.0.html


circuit writer pen
http://www.radioshack.com/product/index.jsp?productId=3964901

Try following the  trace and add a piece of 30 awg wire to it,  should work again solder the wire to the trace and to connection on the Y button.

EDIT: Or try using the circuit writing pin, make sure its dry for a couple of hours before using it shake the pen well before using it

Title: Re: xbox controller help cg2
Post by: 3D0kassiah on August 08, 2011, 06:46:43 PM

do i connect those 2? where i put an X on the ends

Title: Re: xbox controller help cg2
Post by: Rodent on August 08, 2011, 06:50:45 PM

EDIT : IDK if that will work or not could test it with an multimeter on ohms I dont have a controller to  test it with . to see if that is the same trace or not