Acidmods

AcidMods Resources ----- ( These are helpful tools for modding ) => Open Source Code & AcidMods Free Code => Topic started by: 3lite117 on October 14, 2011, 03:32:04 PM

Title: Need help with the ps3 BMU Rapidfire
Post by: 3lite117 on October 14, 2011, 03:32:04 PM: It seems Ive got it all together, but im having a problem changing the modes I know that the led shuts off when in the modes and gives a flash between them, but when I go to change modes I just simply dosent unless I put my finger between the com pin and earth pin on the pic and then press the tac button, also it will work of I put my finger on the Tp18 and then press the tac at the same time, Very strange Ive rewired all solder points used new wire on all connections and still the same problem... Has any one else had this? Im sure I must be doing somthing wrong.. but Its annoying me and I want to get it sorted :boxed:
Ive done loads of 360 installs, but am noob to the ps3 hopefully some one can shed some light on the situation :beg:
Title: Re: Need help with the ps3 BMU Rapidfire
Post by: rafaliyo86 on October 19, 2011, 11:56:39 PM: I had the same problem. I try to do a bridge between leg 2 and 3. Someone (I dont remember who) told me here
Title: Re: Need help with the ps3 BMU Rapidfire
Post by: 3lite117 on October 20, 2011, 04:02:30 AM: Did it work for you after that?
Title: Re: Need help with the ps3 BMU Rapidfire
Post by: hyper999 on October 20, 2011, 08:26:20 AM: Seems to me that there is a problem with your connection between the PIC and the COM line
Title: Re: Need help with the ps3 BMU Rapidfire
Post by: rafaliyo86 on October 20, 2011, 10:42:43 AM: Quote from: 3lite117 on October 20, 2011, 04:02:30 AM
Did it work for you after that?

yes, but it was with hyperÂ´s code
Title: Re: Need help with the ps3 BMU Rapidfire
Post by: 3lite117 on October 21, 2011, 04:02:56 AM: Quote from: hyper999 on October 20, 2011, 08:26:20 AM
Seems to me that there is a problem with your connection between the PIC and the COM line

So what should I be looking for hyper? ive checked the tp solder point and its clean I made sure I didnt over cook the solder point im kinda runnung outa options :help:
Title: Re: Need help with the ps3 BMU Rapidfire
Post by: hyper999 on October 22, 2011, 05:16:17 AM: You have programmed your PIC wrong or wired it up wrong the code works fine on all current PS3 controllers.