Acidmods

AcidMods Resources ----- ( These are helpful tools for modding ) => Open Source Code & AcidMods Free Code => Topic started by: tempermodz on November 15, 2011, 07:44:10 PM

Title: HELP on 6 mode & ps3 3 mode
Post by: tempermodz on November 15, 2011, 07:44:10 PM
 Can someone help me out here, on the xbox 360s 6 mode. What causes to stop working, and
make buttons not work ? Also on the ps3 3 mode the one that fires with R1, that mod also stops working after a few days. Is the chip heating up ??? Since I dont put resistors on the led that goes to the chip ? On one controller that I didnt solder it to the led, is still working and the ones I did without a resistor mess up in a week topz. The 6 mode for the xbox it messes it up usually by making buttons not work. Help please
Title: Re: HELP on 6 mode & ps3 3 mode
Post by: Phantom on November 15, 2011, 10:33:23 PM
pretty much every code here works 100% correctly, when its wired 100% correctly. recheck all your wiring, use resistors if the diagram tells you to use resistors, and you should be good. post some pictures of your wiring and someone might be able to help you out a bit more.
Title: Re: HELP on 6 mode & ps3 3 mode
Post by: tempermodz on November 20, 2011, 10:17:55 AM
Ill try posting some images. But its exactly the same. The only different thing is the resistor. I haven't put one that goes to the led. Unless its the jd programmer thatvi use and the software. I can only use picpgrm on that programmer
Title: Re: HELP on 6 mode & ps3 3 mode
Post by: 3D0kassiah on December 12, 2011, 05:17:09 PM
sure its your wiring thats not up to par post of a pic
SimplePortal 2.3.5 © 2008-2012, SimplePortal