Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => XBOX 360 => 360 Controllers / 360 Rapid Fire Controllers => Topic started by: Luigus on September 08, 2012, 07:43:38 AM
-
Hi Guys. Yesterday i installed Topfire Onto a Cg2 Controller. Everything is wired correctly i'm 95% sure. I used Spurgle's Tut on how to install it. I did however change the ROLleds to red. So when i switched it on it turned on and everything, but the Player 3-4 leds where very dimly lit. When i press the one tactile the led lights up right, but when i hold the tactile in for 4 seconds so that it changes modes, i wait for 4 seconds then BOTH leds (3-4) flash twice (like its in mode 2) but then the leds go off again... and doesn't wan to to go on again.. ill post a video later. But I'm wondering if anyone got the same problem as me before.
-
OK i took a vid, it's very short, didn't have much time... Here you go:
http://youtu.be/Reb5iijrNOo (http://youtu.be/Reb5iijrNOo)
Any help appreciated :)
-
ive never used topfire, but reading through the thread it says when both LED's light up like that, its in custom programming mode. it should be held for only 3 seconds to change modes.
-
lol, can't believe that i didn't see that :0
It actually worked all the time.
thanks BTW