Acidmods

Console Modding------ ( Here you can talk about your favorite Consoles ) => Nintendo Wii => Wii Controllers / Wii Rapid Fire Controllers => Topic started by: Sgt.Ghost on February 27, 2014, 05:35:25 AM

Title: Tact switches
Post by: Sgt.Ghost on February 27, 2014, 05:35:25 AM

Does the tact switches need to be programmed to work the rapid fire.

Title: Re: Tact switches
Post by: rafaliyo86 on February 27, 2014, 06:46:37 AM

No

Title: Re: Tact switches
Post by: Modded Matt on February 27, 2014, 08:23:47 AM

to elaborate on the answer above, There is nothing to program on a tact switch. It as the name states, a switch. on/off. 

But, The programming comes in when you start to discuss what the tact is turning on and off. the tact switch is only an input device connected to the programmed microchip that handles the rapid fire, so no, the switches are not programmed, but what they connect to must be.

Title: Re: Tact switches
Post by: Sgt.Ghost on February 27, 2014, 10:29:24 AM

So your saying that the tact switches does not need to be program. So if I do rapid fire for the wii only the 8 pin dip needs to code and the wires connected to switch will work. Thanks

I pm for the hex code and read the link but no answer.

Title: Re: Tact switches
Post by: Rodent on February 28, 2014, 03:54:15 AM

Quote from: Sgt.Ghost on February 27, 2014, 10:29:24 AM

So your saying that the tact switches does not need to be program. So if I do rapid fire for the wii only the 8 pin dip needs to code and the wires connected to switch will work. Thanks

I pm for the hex code and read the link but no answer.

No need to program the Tact switch (its not programmable) the  8 pin chip is what you program  and  to explain what modded matt was saying was that  some hex codes can be made that where the when you press the tact switch it will change modes to turn on modes  pr turn modes off that are programmed.