Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => Xbox One => Xbox One controllers/Xbox One Rapid fire Controllers => Topic started by: johnboy196 on December 17, 2015, 11:51:38 AM
-
Hi
My rb button on the main board stopped working so of course i desolder the broken rb switch of the main board so i could replace it with a new one everything went well..so of course when i went to replace the new rb switch this is where i messed up the 2 hole that power the switch i burnt out well over heated so there a no go ever time i try to solder the solder will not stay..so is there anywhere else i can power the rb switch from the switch stays in place but just does not work..as the solder points are broke..anyone help..?
Thanks..
-
uploads some photos of the damaged points.
Also there should be a scan of the controller board on this forum somewhere, take a search and look.
-
thanks for replying ..yes was looking at the pictures of the scan board of the controller that has been posted on the forum..just not sure where i could power my rb switch from..theres not much point in me uploading pictures of the damage i have done. the 2 hole that the pins go throw are shot and thats why the solder will not stay on the main board..so of course no power to switch dead..just thought i could solder a bit of wire to the pin of the leg that gives power to rb switch and then solder to the right point on the board but just not sure where..anyone..
Thanks for help
-
theres 4 holes that the pins go thru. you keep saying that 2 pads are destroyed but still are not telling us which 2 are destroyed.
Again, upload a photo so that we know for sure which controller board you have, and that we will provide you with the best help we can.
-
hi thanks for help and replying. i have looked on the forum and found the picture of the board that shows the 2 hole where the pins go through for the rb button. its the hole that is highlighted in purple and the hole down from it they are burnt damaged. are they the power points that are highlighted in purple and the over holes the ground..i cannot upload a picture of my board as my phone camera is bad sorry..hope this explains it a bit better..
(https://acidmods.com/forum/proxy.php?request=http%3A%2F%2Fs3.postimg.org%2F4uih9oasv%2F1537_TBB_zps1750c84f.jpg&hash=f433c899833933ba033528f1bb3730e714f4786e) (http://postimg.org/image/4uih9oasv/)
-
you are gonna have to do a bypass/trace repair. you are going to have to scratch off the little vias that the purple line connects to. The other 3 holes are connected so you should be able to just jump a wire there.
Lower your heat and use flux when working with the vias. these are smaller and more eaily damage from heat.
-
Hi
Right thanks for replying..
Will give this a go and see how i get along hopefully this will get it sorted..
Will let you no how i get along...
Thanks again for your help..
-
Hi
Did like you said and all is working perfect..
so thanks again for the help..
-
Your welcome :tup: :tup:
-
Can someone tell me the size of the tact switch? 6x6x4.3 or 6x6x5, maybe I'm off on both? Thanks.
-
Thru Hole, Right Angle, 6mm x 6mm x 3.85mm
-
Greatly appreciated!