Acidmods

Console Modding------ ( Here you can talk about your favorite Consoles ) => XBOX 360 => 360 Controllers / 360 Rapid Fire Controllers => Topic started by: neilthe4th on May 10, 2018, 11:04:24 PM

Title: Need help with a connector pinout
Post by: neilthe4th on May 10, 2018, 11:04:24 PM

So my friend asked me to fix his plug and play controller cord that has gotten old, on the side of the connector to the controller I didn't take caution to see where eache cable went and the board itself doesnt specify. I'm hoping to find what each of the 7 pins of the controller respond to since I can see the buses that the solder points go to.

Basically I'm asking for a pinout of the port where the plug and play controller connects to. i hope it isn't too much trouble.


(https://s9.postimg.cc/50l3h5e97/IMG_20180511_005456_1.jpg) (https://postimg.cc/image/50l3h5e97/)

(https://s9.postimg.cc/5dchng6uj/IMG_20180511_005533.jpg) (https://postimg.cc/image/5dchng6uj/)

(https://s9.postimg.cc/pxhblxubf/IMG_20180511_005607.jpg) (https://postimg.cc/image/pxhblxubf/)

Title: Re: Need help with a connector pinout
Post by: RDC on May 11, 2018, 07:54:40 AM

The 7 connections of the PnC connector just go to the controller, the 5 connection one needs the USB cable wired up to it.

On your second pic there, the back of the board, left to right.

5v (Red), D- (White), D+ (Green), GND (Black), GND (Shield)

Title: Re: Need help with a connector pinout
Post by: neilthe4th on May 13, 2018, 01:05:53 AM

Thank you so much :D

Title: Re: Need help with a connector pinout
Post by: RDC on May 13, 2018, 12:10:01 PM

Welcome.