Acidmods

Console Modding------ ( Here you can talk about your favorite Consoles ) => Xbox One => Xbox One controllers/Xbox One Rapid fire Controllers => Topic started by: halo2jumper on October 23, 2018, 02:01:45 PM

Title: Elite Controller back buttons for normal controller
Post by: halo2jumper on October 23, 2018, 02:01:45 PM

Im trying to do a mod that uses the elite controller paddle board on a normal controller.

But im not sure if its possible when i look at the elite board.

Any pcb scans or diagrams available?


Im talking about this small board:

(https://abload.de/img/p3xvleuttpldrcdk2mdxb.jpg)


I basicly want to use this buttons for a normal controller.

Title: Re: Elite Controller back buttons for normal controller
Post by: RDC on October 23, 2018, 04:15:57 PM

It's just a common ground button board with a 6 pin connector.

1 - Button
2 - GND
3 - Button
4 - Button
5 - GND
6 - Button

Title: Re: Elite Controller back buttons for normal controller
Post by: halo2jumper on October 24, 2018, 12:19:34 AM

Ok but i want to solder the buttons directly to a normal one controller. Without using the pin connector.

Title: Re: Elite Controller back buttons for normal controller
Post by: RDC on October 24, 2018, 04:33:30 AM

No idea what you're really after then, as that board can't get any easier to figure out. You can see all of the FT spots and traces in your pic there.

FT1 - SW4
FT2 - SW3
FT3 - SW2
FT4 - SW1
FT6 - GND
FT7 - GND

Title: Re: Elite Controller back buttons for normal controller
Post by: halo2jumper on October 24, 2018, 10:31:00 AM

Thats what i was looking for. Thanks for that <3

Title: Re: Elite Controller back buttons for normal controller
Post by: ndanielh on February 26, 2019, 08:16:06 PM

and on the back that points would weld ??

Title: Re: Elite Controller back buttons for normal controller
Post by: aakers369 on November 08, 2021, 05:52:43 AM

I know this is an old thread, but I am also doing this same thing. Everything is soldered up but I am now running into fitment issues. Were you ever able to successfully complete this mod? If so how did you fit the elite controller back onto the xbox controller?