Acidmods

Console Modding------ ( Here you can talk about your favorite Consoles ) => Xbox One => Xbox One controllers/Xbox One Rapid fire Controllers => Topic started by: imran421 on May 17, 2020, 08:07:45 PM

Title: xbox one sync button replacement
Post by: imran421 on May 17, 2020, 08:07:45 PM
Any who can point me please, where to find the sync switch (SW2) on 1708 board. I tried ebay but did not find it.
Thanks
Title: Re: xbox one sync button replacement
Post by: RDC on May 17, 2020, 09:23:57 PM
It's a TL3340AF160QG, same thing they used on the wireless 360 controllers. - https://www.digikey.com/product-detail/en/e-switch/TL3340AF160QG/EG4627CT-ND/1885974 (https://www.digikey.com/product-detail/en/e-switch/TL3340AF160QG/EG4627CT-ND/1885974)
Title: Re: xbox one sync button replacement
Post by: imran421 on May 19, 2020, 01:43:19 AM
Thanks for the reply. What is the best way to install them. Hotair or soldering
Thanks
Title: Re: xbox one sync button replacement
Post by: RDC on May 19, 2020, 01:49:36 AM
Depends which you're more comfortable with and/or have access to. I'd remove the old one, clean of the pads with solder braid, then rubbing alcohol, then a few dabs of solder paste and hot air it on there.
Title: Re: xbox one sync button replacement
Post by: imran421 on May 19, 2020, 07:36:50 AM
I think the hot air will melt the switch. it is way to small to solder.
Thanks
Title: Re: xbox one sync button replacement
Post by: RDC on May 19, 2020, 10:26:14 AM
The hot air could melt the switch, if used improperly, not will melt it because you think so.
SimplePortal 2.3.5 © 2008-2012, SimplePortal