Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => Xbox One => Xbox One controllers/Xbox One Rapid fire Controllers => Topic started by: gamingbuff1993 on August 28, 2020, 01:39:44 PM
-
Hello guys, I am hoping if someone can help with my controller.
I have a controller 1708 model
Issue - Works fine wired but the Bluetooth range drastically decreased. The controller only stay connected when it is very close to the console ( say 10cm ), otherwise it will not stay connected, I tried it with 3 different consoles so i know that it is not the wifi pcb that is faulty on the console. I also opened the controller to see if the antena cable was loose or any damage/corrosions, but everything seemed fine. May be I should replace antena cable and see if it works but before I do that, I am curious if someone has had the similar problem and was able to solve it. Any help/guidance will be much appreciated.
Also, I have windows and macbook and it is wierd that it connects normally with those devices without any range issues. :wacko:
UPDATE: I also updated the controller but still no luck
-
could be a problem on your wireless board on Xbox, you can see the board just removing the plastic cover of the console
-
Hello guys, I am hoping if someone can help with my controller.
The controller only stay connected when it is very close to the console ( say 10cm ),
UPDATE: I also updated the controller but still no luck
I have the same problem. Does not connect to a wireless adapter on a Windows 10 computer. I.e., there is a connection at 10 cm. more than 10 cm connection is broken. Have you found a solution?
-
bluetooth booard is doubledeck. check it. maybe some caps broken.
-
bluetooth booard is doubledeck. check it. maybe some caps broken.
The software update didn't help. I found out that the Board where the MCU is located is faulty. On a good Board, the resistance on the C35, C46 - MOhm, and right capacitors - 3 kOhm. On a faulty Board, the resistance on these capacitors is 400 Ohms. Any ideas?
(https://i.postimg.cc/X7WSxtZV/20201014-185320.jpg)
-
sorry i dont check capacitors resistnace too often, cuz they are capacitors, not resistors. take them one by one and check if resistance go to higher values.
-
do you know where the bluetooth module is on this board?
smaller pcb is ok and i swapped them.
-
I have the same problem above 10 cm. The pad loses range from the console
-
@pad123
do you know where the bluetooth module is on this board?
smaller pcb is ok and i swapped them.
Have you figure out where the problem comes from? What do you mean when you say "smaller pcb"? The one where the MCU is soldered on?
-
I have this same issue.
I swapped Z10, Z11, C77, RFF2, Z4, C13, T2, Z2, Z1 from working board and nothing change.
This is strange, because this isn't work only with xbox. When i connect wireless with notebook range is fine.