Acidmods

Console Modding------ ( Here you can talk about your favorite Consoles ) => PS4 => PS4 Controllers/PS4 Rapid Fire Controllers => Topic started by: popahly on August 31, 2020, 04:23:30 AM

Title: looking for help
Post by: popahly on August 31, 2020, 04:23:30 AM

Hello everyone, I have an old motherboard for the controller, I want to make bridges for damaged places. Just for training. Is there anyone to help me.

(https://i.imgur.com/S1PaK5j.jpg)

Thanks

Title: Re: looking for help
Post by: RDC on August 31, 2020, 09:04:19 AM

There are no easy to solder to spots on the DS4 controllers. You'll need to clean all of that up first with a Q-tip and some rubbing alcohol. Then follow the traces from the damaged areas and solder to what is left of the trace or follow it until it gets to a via and prep and solder it there.

(https://www.acidmods.com/RDC/DS4/JDM-001%201-889-300-21%20RS%20Bottom.jpg)

Title: Re: looking for help
Post by: popahly on August 31, 2020, 01:50:27 PM

Thank you very much, professor. Excuse my ignorance of this matter. Can you direct me more with just one example. I tried a lot to keep track of the points, but I failed.

Title: Re: looking for help
Post by: RDC on August 31, 2020, 04:37:21 PM

If I'm the teacher, then you should be learning. ;) Save the image there and use something like Paint or PhotoShop so you can zoom in and trace them out.

Title: Re: looking for help
Post by: popahly on September 01, 2020, 12:00:41 AM

A big honor for me..I will do that. Thank you

Title: Re: looking for help
Post by: wickated on September 05, 2020, 09:23:31 AM

tips
1) dont use rosin flux with leadfree soldering repairs
2) joint from resistor goes directly to MCU but track is bold so u can scratch coating and solder jumper wire to it
3) for l3 button press solder  jumper wire in here :
(https://sun1-92.userapi.com/oS93sTwBiL6zaB4_lDCLL_CpE4zybeN6B7ReZw/1k5e0-Ik4ek.jpg)

Title: Re: looking for help
Post by: popahly on September 06, 2020, 05:21:13 AM

Thank You so much..