Acidmods

Console Modding------ ( Here you can talk about your favorite Consoles ) => Xbox One => Xbox One controllers/Xbox One Rapid fire Controllers => Topic started by: zis2104 on October 13, 2020, 02:35:41 PM

Title: How desolder button sync xbox one 1537
Post by: zis2104 on October 13, 2020, 02:35:41 PM

I don't know help me please

Title: Re: How desolder button sync xbox one 1537
Post by: RDC on October 13, 2020, 03:19:01 PM

It's a SMT part. The connections are all pretty much underneath it and getting it desodlered with an iron means you'll probably ruin it, unless you use 2 of them and heat the 2 ground points in the front and the 3 main spots at the back at the same time. Be careful as too much heat and you'll just lift the pads/traces.

The proper way to remove/install it would be with a hot air setup and some flux.

Title: Re: How desolder button sync xbox one 1537
Post by: zis2104 on October 13, 2020, 06:17:30 PM

what if i used a thin copper wire and connected it to the various points of trace? i have xbox 360 controller pcb, will i try those for now?

Title: Re: How desolder button sync xbox one 1537
Post by: RDC on October 13, 2020, 07:34:14 PM

If you want to rip it off the board and ruin the pads/traces then rewire it be my guest, but that's a mess of work to do versus just doing it the right way.

Title: Re: How desolder button sync xbox one 1537
Post by: wickated on October 22, 2020, 05:54:38 AM

sry i don get wat buton u r toking bout