Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => PS4 => PS4 Controllers/PS4 Rapid Fire Controllers => Topic started by: zis2104 on January 07, 2021, 02:57:19 PM
-
i have two ps4 jdm 001 controllers that when i move the analog r2 and l2 they receive the input as if i was clicking them
-
They use the same power Rail so either the thumbstick is bad or the trigger pads are bad, maybe both.
-
should i change the sensors? because i changed the circuit board
-
If you mean the green film, that does nothing, that only completes the circuit. Your fault is on the actual pcb or trigger pads not the green film.
-
do I replace the analogs then? but if the error is on the circuit where I mount the green film then the cards are to be thrown away?
-
Clean or replace the analog sticks
Still broken after that? Replace the trigger pads
-
left stick Y - R2
right stick Y - L2
if u walk forward while pressing r2 then change pot , its dead
-
When i move analogs r2 go itself, but i replace 1 analog but i used analog for ps4 controller slim/pro...is bad?
-
close the topic, i selled them by ebay.