Acidmods

Console Modding------ ( Here you can talk about your favorite Consoles ) => Xbox One => Xbox One controllers/Xbox One Rapid fire Controllers => Topic started by: Adampark on July 02, 2021, 11:12:18 AM

Title: Xbox Elite series 2 Rapidfire mod
Post by: Adampark on July 02, 2021, 11:12:18 AM

Hi, I currently have rapid fire kit and was looking too fit it on elite series 2 controller But cant locate the solder points on the elite series 2 boards I have had a look through the diagram put up for the series 2 and can find a couple but not all of the points

Power: j3 pin 3
Led: pin 10 j5 (charge led)
B button:DB10
Sync: ????
A Button ???
LT:DB 39
RT:DB 39
Earth: PIN 1 j3

Would this be correct does any one have an idea where the sync and b button solder points are?

Kind regards

Title: Re: Xbox Elite series 2 Rapidfire mod
Post by: RDC on July 02, 2021, 02:14:11 PM

There really aren't any. The schematic for that top board is in the 1797 thread. On the Top board, you can use either side of R17 for A, then either side of R34 for Sync.

Title: Re: Xbox Elite series 2 Rapidfire mod
Post by: Adampark on July 03, 2021, 06:26:50 AM

Thanks a lot mate going to give this a go now, will let you know the outcome.

Thanks Adam

Title: Re: Xbox Elite series 2 Rapidfire mod
Post by: Adampark on July 03, 2021, 08:31:58 AM

Right I have the mod working but when I put the mod into the drop shot mode or Jumpshot mode, it keeps the button pressed it doesn?t release. The Rapidfire works fine just the Jumpshot dropshot mode any ideas to why it would keep it pressed.?

Thanks Adam

Title: Re: Xbox Elite series 2 Rapidfire mod
Post by: StxvxC on November 02, 2022, 02:29:35 PM

Hello Adampark, its been a while since this thread has posted, but I wanted to ask if you ended up getting the mods to work on your series 2? and if so, what chip did you use and would you mind showing pictures if you still have them available? I'm struggling a lot on mine.