Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => Xbox One => Xbox One controllers/Xbox One Rapid fire Controllers => Topic started by: ReGORE on March 12, 2022, 03:33:07 AM
-
Hello!
I would like to contact you with a stick replacement. After replacing the bad stick with a new one (original quality), it turns out to the edge after I put it together. How can this be solved? I am attaching a picture for you to see it
(https://kepkuldes.com/images/71a569df78d1f36bc1d6a3d6db38891b.png)
-
Send pics solder point
-
A 82kOhm resistor is put between it, so the center is on the right place but it doesnt go to the edge completely. Is there any general solutions for this? What did I do wrong? Im using original parts only.
(https://kepkuldes.com/images/36f53c88972d3c5732818cb545638bac.md.jpg)
(https://kepkuldes.com/images/d7dec4b9f243d5531a7acd0ef3312fe3.md.jpg)
-
I don't think so, unfortunately the motherboards are programmed on purpose for the mounted sensor, at the limit instead of the resistors you could use the 50k smd potentiometers to adjust them or change the sensor with a different value. the sensor mounted gave 10ohm?
-
Not quite. 9,5 - 9,8 Ohm
-
So you're saying I should use a 50k ohm smd potentiometer to fix this problem? Where should it be mounted?
-
remove the resistor. just move the analog potentiometer without desoldering, and with tweezers or another tool turn the guide pin in the direction that you are pulling and fit the potentiometer, keep doing it until you get the desired position, this works for one, 360, ps4 and ps5